(Dead Boot Repair) UNBRICK OnePlus 7T Pro Europe 10.0.5

Is your OnePlus 7T Pro stuck in a dead boot state or not responding after a failed update or flash? This guide will help you recover (unbrick) your OnePlus 7T Pro (Europe variant) running OxygenOS 10.0.5, using a Qualcomm emergency download (EDL) method.

⚠️ Disclaimer: Proceed at your own risk. Flashing via EDL mode can void your warranty. This guide is for educational purposes only.

🔧 UNBRICK OnePlus 7T Pro Europe 10.0.5 (Dead Boot Repair)

🛠 Step-by-Step Instructions

1. ✅ Install Qualcomm USB Drivers

1. Download and install Qualcomm QDLoader HS-USB drivers.
2. Reboot your PC after installation.
3. Tip: On Windows 10/11, you may need to disable driver signature enforcement to install unsigned drivers.
4. 
   
5. 2. 📥 Download and Extract the Firmware

• Download the OnePlus 7T Pro 10.0.5 EDL firmware from the Google Drive link.
• Extract the ZIP file using 7-Zip or WinRAR.

You should see:

• MSMDownloadTool.exe
• EDL firmware folder
• Other necessary flashing files
• 3. 💀 Boot into EDL Mode (Emergency Download Mode)
• 📦 What You’ll Need:

• A PC running Windows
• Qualcomm drivers
• OnePlus 7T Pro 10.0.5 EDL Firmware (Europe variant)
• 🔗  Download Firmware (Google Drive)
• https://www.youtube.com/channel/UCX04gGkciczwaflnSyFTsWw
• QDLoader HS-USB Drivers (Qualcomm)
• MSM Download Tool
• A USB cable

If the  phone is completely dead:

Best smartphone

• Method 1 (Button Combo):
• Hold Volume Up + Volume Down together.
• Connect the phone to the PC via USB while holding both buttons.
• Method 2 (Test Point - Advanced users):

• Open the back panel of the phone.

• Short the test points using tweezers and connect USB.

Once connected, check Device Manager. It should show Qualcomm HS-USB QDLoader 9008.

4. ⚙️ Flash with MSM Download Tool

1. Run MSMDownloadTool.exe as Administrator.
2. Select your target variant if prompted (Europe).
3. Click Start to begin flashing.
4. Wait patiently — flashing may take several minutes.
5. Do not unplug or disturb the phone during this process.
6. 
   
7. 5. ✅ Boot Up and Initial Setup

Once flashing is complete, the phone will auto-reboot.

•  Disconnect it from the PC.
• Wait for it to boot into the OxygenOS 10.0.5 setup screen.
• You're done!
• 
  
• 💬 Final Thoughts

Unbricking a OnePlus 7T Pro via EDL mode is a lifesaver when your device refuses to power on or respond. As long as the Qualcomm chipset is detected in 9008 mode, there's a good chance of full recovery.

If you found this guide helpful, consider bookmarking or sharing it to help others in the same situation!

Need help or stuck on a step? Drop a comment below or reach out on forums like XDA.